cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
ziele_o2k
New member
1 0 0 0
Message 1 of 2
347
Flag Post

Designjet 1300 configuration problem

HP Recommended
hp designjet 1300
Microsoft Windows 10 (64-bit)

Hi,

 

I have problem with configuration of Designjet 1300.
In my 1300 i have 2 rolls loaded for example: Roll 1: 594mm, Roll 2: 840mm.
When I'm printing on 840mm (Roll 2) and paper is out, Designjet is swiching to roll 1 (594mm) and prints cutted drawing.
I whant to configure my 1300 so it will not plot drawings on any other roll and will stop plotting untill i will load new 840mm paper roll.

 

Thanks in advance!

1 REPLY 1
JackB44
Level 3
60 60 1 14
Message 2 of 2
Flag Post
HP Recommended

Roll switching is settings inside of printer. Take a look at User's Manual - you will find a nice description of which printer setting affects what, so you will be able to set it as you wish.

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation