cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
1937Chevy
New member
2 1 0 0
Message 1 of 2
232
Flag Post

HP T120 DesignJet

HP Recommended
DesignJet T120
Microsoft Windows 10 (64-bit)

Hello Everyone,

I have a DesignJet T120. I used to be able to print (AutoCad 2018) a (C) size plot (24" x 18"). The T120 uses a 24" wide roll of paper. Since I have upgraded to AutoCad 2019, I can no longer print a (C) size plot. It makes me plot (D) size which is (24" x 36"). I have gone through the plotter Preferences and Properties with no luck. If I go through the filter paper sizes and make sure the (C) is there, when I select it, it goes back to (D). Do I need a new driver? 

 

1 REPLY 1
rasheddul
Level 7
634 609 35 85
Message 2 of 2
Flag Post
HP Recommended
Please check my below link for details :


https://h30434.www3.hp.com/t5/DesignJet-Large-Format-Printers-and-Digital-Press/Paper-mismatch/m-p/6...



Just completely setup your printer driver and get as like driver properties.....


Regards
Rashed
Regards/Rashed
https://www.linkedin.com/in/rasheddul
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation