• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Do you need the WPS PIN to connect your printer? Click here for tips and tricks!
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
HP Recommended

Hi

Any suggestions?

HP T920 stuck in low power mode until reboot..then does it again after a while..if you send a job to it whilst in low power mode it doesn`t wake up..only comes back to life after a reboot.

 

2 REPLIES 2
HP Recommended

hello
We had a similar problem 
The fault was because the disk stopped spinning . 
After replacing the hdd ploter started working as it should

 

I replaced with this one from ebay 

https://www.ebay.com/itm/284069604611

HP Recommended

Thanks for your reply...that is a good suggestion..I will check it out.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.