cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
silverfoxnz1
New member
1 0 0 0
Message 1 of 2
184
Flag Post

I have a Z5400 that erros when doing a colour calibration with 79.2:04

HP Recommended
Microsoft Windows 7 (64-bit)

The operator is constantly getting a crashing device when performing a colour calibration.

However I cannot see the error 79.2:04 in the service manual.

has any body had experience with this??

1 REPLY 1
HJ47
Level 3
69 68 2 3
Message 2 of 2
Flag Post
HP Recommended

Hi,

please upgrade the firmware of your printer.

Thanks

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation