cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
Bob1032
New member
1 0 0 0
Message 1 of 2
388
Flag Post

Latex 360 prints slow

HP Recommended
HP Latex 360 Printers
Microsoft Windows 7 (64-bit)

For the first 6" of printing, the printer runs at full speed.  After that, it slows down and the carriage stops for about 1 second at each end of the pass before continuting.  The   Interpass delay is set to zero,  I disabled the OMAS and replaced all the printheads, but it's still the same.   Any ideas?

1 REPLY 1
1111SLV__
Level 2
Level 2
20 19 1 1
Message 2 of 2
Flag Post
HP Recommended

Hello

I invite you to use HP Latex Forum https://hplatexknowledgecenter.com/forum/printers for future questions on your HP Latex printer, it will be easier to help you form there. Regards

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation