• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Do you need to install your printer? Click here for tips and tricks!
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
HP Recommended
Designjet Z2100
Microsoft Windows 10 (64-bit)

I'm having a devil of a time getting a z2100 working.  The printer boots up fine but any print job (including printhead alignment test and any system report print) sends the carriage to the straight to the left where it crashes and yields a 79:03 error.  The power supply, Main PCA, Formatter Board (with hard drive) and print mech PCA have all been replaced with no effect.  Does anyone have any ideas what it could be?

2 REPLIES 2
HP Recommended

keep calm....

 

try PCL driver

 

if still same, I would try to replace        scanaxis motor....

HP Recommended

Don't think it can be PCL as not  connected to a computer and exhibiting this behavior even when printing diagnostic reports.  Why do you think scan-axis motor?

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.