cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
Roy_Kuzmich
Level 6
217 187 21 32
Message 1 of 3
276
Flag Post

T730 - Not Rewinding - Stopping Mid Print

HP Recommended
T730

 

Hi All,

 

When loading a roll on a T730 it loads fine, cuts the straight edge but then does not rewind back to the print start point.

thus, the client is left with additional lead edge.

Has anyone seen this yet?

Also, I am told that it occassionally stops mid print. 

There are no error codes on the unit that leasd to any of these issues and i am looking for some guidance.

 

Thank you for any help.

 

Roy K

Tags (1)
2 REPLIES 2
hriosm
Level 3
42 24 2 0
Message 2 of 3
Flag Post
HP Recommended

Hi,

I have the exactly the same problem. Did you find the solution?

Regards

Was this reply helpful? Yes No
Roy_Kuzmich
Author
Level 6
217 187 21 32
Message 3 of 3
Flag Post
HP Recommended

Check the Spindle (one end with gear) can move out of position causing some friction.

Also , I have found on all newer HP's that the encoder strip needs to be cleaned more often.

Clean and calibrate the line sensor. ( on side if Carriage/PH)

 

Hope these things help

 

Roy K

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation