cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
jasonmiamifl
Level 7
880 810 37 84
Message 1 of 5
1,766
Flag Post

designjet Z3200 44" 01.0:10 error

HP Recommended

Recently I have a Designjet Z3200 44" with error 01.0:10 & carriage box did not move at all.

 

I replaced with new trailing cable & nothing.... google this error code & no hints.

 

Printer was working beautifuly & flawlessly.  then miday I saw the red led & that was the end.

 

mainboard ?    formatter works...new trailing cable.. 

 

Thanks in advance for your kind help.

4 REPLIES 4
jasonmiamifl
Author
Level 7
880 810 37 84
Message 2 of 5
Flag Post
HP Recommended

Just download the service manul & it said 01.0   main pca..   1   is print mech.

 

So I will try to change another pca.....

Was this reply helpful? Yes No
davidzuts
Level 13
7,130 7,062 558 1,025
Message 3 of 5
Flag Post
HP Recommended

On these machines you need to change with a new unused main pca. If you do not you stand a very good chance of having the machine never work again since the print mech will want to write to the main board and when it can not it causes all sorts of issues. When you use a new part the print mech can write to the new board. If a used board there is now conflicting information as to model number, serial number, etc which can cause issues.

Was this reply helpful? Yes No
jasonmiamifl
Author
Level 7
880 810 37 84
Message 4 of 5
Flag Post
HP Recommended

Thanks, David.

 

I had located a brand new one in China $200 included shipping. There are many used one for sale on Ebay & I guess

those were defective. Myself bought 2 from past & never be able to repair any machine.

 

New carriage box working good & fixed 02.1:10 error. Next  I will use another new carriage box to

repair another machine with error 79:04 , excatly same second when error 02.1:10 came up.

 

thanks for your advice.

Was this reply helpful? Yes No
TimFromLPS
New member
4 4 0 0
Message 5 of 5
Flag Post
HP Recommended

Hi David,

That is incorrect. The main PCA (main logic board) does not pair to anything. The Formatter pairs to the printmech board. You can install a used printmech board and a used main PCA. If you swap in a used printmech board, you will need a virgin formatter at that point (or the formatter previously paired to that particular printmech). Make sure you get the correct revision: either A or B. Formatter, Printmech, and Main PCA all require you to match your machine's revision (A or B), and --contrary to the service manual-- all but the formatter require you to match your machine's length (44" in your case). 

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation