12-20-2018 06:56 AM
The T2500 will not load paper from either roll, I tried a new roll of paper with same results, the carriage keeps going back and forth looking for the edge, loading in and keeps saying correcting skew. too bad you cant load video to show what its doing. Please help, Thanks
05-16-2019 02:24 PM
I have the same issue, it’s happening on tray 1 so I switched tray 1 roll with tray 2 roll and tray 1 started to work but now it’s doing it on tray 2 so I thought it was the roll itself. So I swapped the roll with a new roll and still get skewing message. Cleaned encoder strip and still skewing. Only thing I can think of is the software.
05-16-2019 03:43 PM
Most likely the line sensor is dirty, this is different than the encoder strip. The line sensor is mounted on the carriage on the left hand side. This is the sensor that detects page sides and leading edge so I would check that first. Hard to see but I would use a moist q-tip to clean it.
05-17-2019 11:33 AM
the problem is within the carriage sensor/eye not being able to read paper loaded because of residue left from ink. You have to remove the sensor/eye from the right side of the carriage it is 2 screws and should be very easy to do and accessible even with the carriage docked. I wouldn't recommend using a q tip as it is quite deep inside. It worked for me thank you guys.