cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Know the Benefits of your HP account

    Connect with HP support faster, manage all your devices in one place, view warranty information and more– Click Here

    Information
    Fix Windows 10 Update Issues

    Resolve Windows 10 or update issues on HP computer or printer– Click Here

  • post a message
  • ×
    Information
    Know the Benefits of your HP account

    Connect with HP support faster, manage all your devices in one place, view warranty information and more– Click Here

    Information
    Fix Windows 10 Update Issues

    Resolve Windows 10 or update issues on HP computer or printer– Click Here

  • post a message
Highlighted
New member
1 0 0 0
Message 1 of 5
1,080
Flag Post

Error 08:11 T795

HP Recommended
Designjet T795 CR649C
Microsoft Windows 10 (64-bit)

My T795 plotter will not get past 1%. The 2nd LED is flashing. I cannot update firware because it won't recognize the USB stick in either the front panel port or the usb port on the formatter on reboot. I reseated the formatter, replaced the 3v battery and rebooted several times. Don't know if the hard drive is bad or the formatter board is bad or both.

4 REPLIES 4
Highlighted
Level 2
19 18 0 4
Message 2 of 5
Flag Post
HP Recommended

 

 

Hello /. 

It looks that your hard disc  is dead . 

It should start loading firmware from hdd 1% 10% 50% 

Try to replace hdd 

 

Like this one 

https://www.ebay.co.uk/itm/283009421360

 

 

0 Kudos
Highlighted
Level 1
10 8 0 0
Message 3 of 5
Flag Post
HP Recommended
Hi its The Formatter board at first surely , and then after replaceing the board , check the Hard Disk
0 Kudos
Highlighted
New member
1 1 0 0
Message 4 of 5
Flag Post
HP Recommended

I replaced the hard drive and installed new firmware. The plotter has been working ok since.

0 Kudos
Highlighted
Level 1
10 8 0 0
Message 5 of 5
Flag Post
HP Recommended
It depends on the LED lights on formatter too , and you should check which one is off and which one is on and which one is blinking , and then you can find out which part needs to be replaced , HDD ,Formatter, Main PCA and Power Supply
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation