cancel
Showing results for 
Search instead for 
Did you mean: 
MotorCityWraps
New member
1 0 0 0
Message 1 of 2
131
Flag Post
HP Recommended

Hp 360 Latex print head failure after 20 feet

Hp Latex 360
Microsoft Windows 10 (64-bit)

Hello all,

I have an HP 360 latex machine that runs good. I have recently started experiencing issues when printing. Example on a panel that measures 54" wide x 12' long the print starts out perfect. About the last 3rd of the print, a printhead fails. It will spray magenta ink over the entire print. There will be an error message on the front panel regarding the print head but when the print finishes, the error will automatically be resolved. magenta 1.jpgmagenta 2.jpg

 

I have downloaded the newest firmware from September. I drive the printer with SAI 2019. I use only OEM inks. I download the appropriate profiles for the media. I have done print head alignments, cleanings, etc. 

 

I have replaced the print head carriage, print head motherboard, and even replaced all printheads with brand new print heads. I do sometimes receive a trailing cable error. But that is intermittent. 

 

Any ideas? I have attached 

1 REPLY 1
skuks
Level 5
192 190 12 22
Message 2 of 2
93
Flag Post
HP Recommended

Hp 360 Latex print head failure after 20 feet

check this link and ask there:

https://hplatexknowledgecenter.com/forum/default/strange-problem-after-smk3

looks similar problem after replacing - not good electrical contact somewhere...

Reply
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation