In my plotter, I have noticed the printheads are not being capped when in the parking position. I can see from the side (no right cover) that caps in service station move more to the front so the printheads are not covered/capped. I have tried the service station diagnostic and service station calibration but still not capping. What can I do? Please help me.
Remove the right cover and examine the service station closely to make sure there is not foreign material blocking the movement. There is also a manual service station drive on the back of the service station that you use a t-10 torx to move the service station. You can try to manually cap the printhead to confirm the station works.
If you find the information provided useful or solves your problems, help other users find the solution easier by giving kudos and marking my post as an accepted solution.