• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The Poly Phones Knowledge Base is live! We look forward to helping you with common issues and troubleshooting advice!
Locked

‎03-18-2014 11:16 AM

HP Recommended

I am familiar with the Incoming Signal Validation outlined in UC 4.0.1 and above's Admin Guide as outlined on Table 9-2; Incoming Signal Validation

 

I'm looking to see if there is a way to have Polycom UC phones will only answer calls intended for an  AOR which is currently registered on the Polycom UC phone.

 

Example, I have a Polycom phone registered to Foo@1.1.1.1 on the public internet.  Someone SIP scans the IP address and finds the phone and begins to send random calls to that phone such as 1001@1.1.1.1, 1002@1.1.1.1. 

 

Is it possible to only allow the phone to ring for calls addressed to Foo@1.1.1.1?

 

thank you!

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.