2215-EIT Failure VA boot record read failure. Ensure Drive with VA Image Installed correctly

[jgarciamori]

I have an HP DC7800P SFF, with the same problem, this problem begun when the clock battery was replaced and The systems lost the config.

AMT 3.0  corrupted ???

I had applied  your steps , and the test to  the DISK DRIVE were ok, hard disk approved.

another solution ?

regards

Julio

[mdklassen]

> ... with the same problem ...

Using the "search" function within this forum, I found that there are at least ten messages that mention '2215-EIT' in their "Subject" lines. Do any of them have a solution for your "same" problem? For example, I found:

------------------------------------------------------------
Blessed_Walidi
‎12-04-2016 03:53 AM 

Dear Friends!

first u need to go to the setup and then in setup need to go to system security
then when open system security
then enable VTx and VTd save the settings and reboot the system.
and enjoy it.
i tried it on three dc7800 machines.
------------------------------------------------------------
Amir_
‎07-30-2013 11:31 PM 
pls read this manual of 14 pages
and try to disable the VA or change boot sequence from VA to  normal boot
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01159978/c01159978.pdf
------------------------------------------------------------
HardBeatZ
‎10-12-2012 10:10 AM 

According to the user manual:  http://goo.gl/Ua2OL

This is from the Virtual Application.
Starting on page 5 in the manual it discusses the VA application.
Try the outlined steps and post back your results.
------------------------------------------------------------