cancel
Showing results for 
Search instead for 
Did you mean: 
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
Murtaza_Arif
New member
2 1 0 0
Message 1 of 4
256
Flag Post

6 BEEP ON START UP

HP Recommended
HP Z600
Microsoft Windows 10 (64-bit)

HP z600 Beep 6 times then after 2 seconds beeps again 6 times.. this happened after i change some settings on the BIOS PCIe to (Compute)

3 REPLIES 3
Prométhée
Level 16
Level 16
6,631 6,555 727 2,596
Message 2 of 4
Flag Post
HP Recommended

hi

 

The Diagnostic LED blinks red 6 times and the system beeps 6 times (once per second), then a 2-second pause follows:

This indicates a pre-video graphic card error.

To resolve the issue, complete the following steps:

1) Reseat the graphics card.

2) Replace the graphic card.

3) Replace the system board.

 

" this happened after i change some settings on the BIOS PCIe to (Compute)"

try to reset the bios to default first

 

 

 


Please remember to mark the answers this can help other users
please click on the accept as solution button if message provided an answer to the problem >

was this reply helpful , or just say "thank you " ? Click on the yes button 





Desktop-Knowledge-Base
Was this reply helpful? Yes No
Murtaza_Arif
Author
New member
2 1 0 0
Message 3 of 4
Flag Post
HP Recommended

my system is not showing any display its just beep 6 times with red light.

I try every step that you mention.

reseat graphic card

replace graphic card

but still its giving 6 beeps

I also try to reset CMOS take-out battery press CMOS button for 5-10 sec but nothing happen.

my system still giving 6 beeps with red light

Was this reply helpful? Yes No
Prométhée
Level 16
Level 16
6,631 6,555 727 2,596
Message 4 of 4
Flag Post
HP Recommended

did you try to boot without the graphics card?
what exactly did you change in the bios?

 


Please remember to mark the answers this can help other users
please click on the accept as solution button if message provided an answer to the problem >

was this reply helpful , or just say "thank you " ? Click on the yes button 





Desktop-Knowledge-Base
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation