cancel
Showing results for 
Search instead for 
Did you mean: 
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
IndSal
Level 1
2 1 1 0
Message 1 of 2
1,578
Flag Post

Solved!

HP EliteOne 800 G1 doesn't Start after Upgrade BIOS 2.73 Rev.A

HP Recommended
HP EliteOne 800 G1
Microsoft Windows 10 (64-bit)

After succesfull installation of BIOS 2.73 (Released 24.01.2018) the PC doesn't start at all.

The power led is intermittently with red light and it starts beeping for several times, after that the fans starts at full power until you remove the power cord.

We tried to remove Motherboard battery and power for some minutes but the situation doesn't change.

Please help us to recover the bios or to reset factory configuration.

 

Thank You in advance

1 ACCEPTED SOLUTION

Accepted Solutions
IndSal
Author
Level 1
2 1 1 0
Message 2 of 2
Flag Post
HP Recommended

Hello All,

i found the solution by using Emergency BIOS Recovery by USB Drive.

-Downloaded the previous BIOS Version 2.71 and extracted files from the package.

-Formatted a FAT32 USB Drive.

-Copied the .BIN file in the USB Root (from the DOS FLASH folder extracted previously)

-Started the PC with the USB drive connected.

 

The BIOS recovered Itself automatically from the USB Drive.

 

Thank you

 

Goodbye

 

View solution in original post

Was this reply helpful? Yes No
1 REPLY 1
IndSal
Author
Level 1
2 1 1 0
Message 2 of 2
Flag Post
HP Recommended

Hello All,

i found the solution by using Emergency BIOS Recovery by USB Drive.

-Downloaded the previous BIOS Version 2.71 and extracted files from the package.

-Formatted a FAT32 USB Drive.

-Copied the .BIN file in the USB Root (from the DOS FLASH folder extracted previously)

-Started the PC with the USB drive connected.

 

The BIOS recovered Itself automatically from the USB Drive.

 

Thank you

 

Goodbye

 

View solution in original post

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation