02-13-2020 12:19 PM
When plugged it the start button flashes and when i press the start button nothing happens. Whats wrong?
02-13-2020 12:25 PM
This will not work for everyone, but you may be lucky?
HP Notebooks and Mobile Workstations -
No Power, No Boot, No Display When Power Button Is Pressed
NOTE: Be sure the battery is installed in the computer and it has sufficient power before continuing. Due to the design of the Embedded Controller/Keyboard Controller, the power supply must be disconnected and the computer must be powered with battery power to reset the Embedded Controller/Keyboard Controller.
Unplug the AC power from the computer.
Press and hold the power button for more than 12 seconds.
Release the power button (after at least 12 seconds).
The computer will power on and should boot normally after releasing the power button.
Re-connect the AC power to the computer.
NOTE: In case the battery is not charging after performing the steps to reset the Embedded Controller, unplug and re-plug in the AC power again.
A Nod Is As Good As a Wink...
02-13-2020 12:53 PM
Thank you for your reply. This doe's not have a battery supply. Gets power from 110 volt plug . This is a tower a705w. The only battery is the small 1032 button batter in the mother board , and i replaced it. still won't startup.