cancel
Showing results for 
Search instead for 
Did you mean: 
Salvo2
New member
2 0 0 0
Message 1 of 4
1,261
Flag Post

HP Support Assistant kills HP 280 G1 MT (bios)

HP Recommended
HP 280 G1 MT
Microsoft Windows 7 (64-bit)

The Support Assistant told me to update the BIOS.  When I did, it killed my computer.  Corrupted BIOS

3 REPLIES 3
Grzwacz
Level 12
Level 12
6,774 6,758 637 1,524
Message 2 of 4
Flag Post
HP Recommended

Greetings Salvo2,

Welcome to the forum.

I am not a HP employee.

 

You may be able to flash the BIOS (Link to BIOS update) by following instructions here (Link). Note, this BIOS update is also supported on WIndows 7.

 

Check BIOS update instructions when Windows does not start.

 

You may have to contact HP Support if flashing the BIOS fails.

 

Regards

 

 

0 Kudos
KILLEARN
New member
1 1 0 0
Message 3 of 4
Flag Post
HP Recommended

I had this issue as well, support assist detected that there is an update for my bios, I ran it and it seemed to install sucessfully, my pc turned off and when it powered back on I just hear eight long beeps and nothing happens further, how do I roll back or recover my pc bios update that failed?

0 Kudos
Stebo1
New member
1 1 0 0
Message 4 of 4
Flag Post
HP Recommended

Hello,

 

I experienced the same problem, only working solution was the one I found here: https://h30434.www3.hp.com/t5/Desktop-Boot-and-Lockup/Black-screen-after-BIOS-update-on-280-G1-MT-Bu...

 

Regards

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation