cancel
Showing results for 
Search instead for 
Did you mean: 
AdnanMumtaz
New member
3 2 0 0
Message 1 of 6
1,234
Flag Post

ME Firmware Update failed/Error sending end of post message to ME: HECI disabled, proceeding w boot

HP Recommended
HP Pavilion All-in-One - 24-b105nx
Microsoft Windows 10 (64-bit)

My computer had been working very fine until yesterday when my son complained it wasn't booting i noticed this message while booting "ME Firmware Update failed/Error sending end of post message to ME: HECI disabled, proceeding w boot" 

 

It takes very long to boot and the computer performance has decreased dramatically, I tried to find solutions online and one of them was to restore Bios or update, i tried both but the error doesn't go. All the drivers are up to date of Intel as well as Microsoft Windows 10, I am an IT guy myself but not able to find a solution for this hardware or FW issue.

 

I will appreciate if someone can help me.

5 REPLIES 5
krzemien
Level 7
731 713 31 171
Message 2 of 6
Flag Post
AdnanMumtaz
Author
New member
3 2 0 0
Message 3 of 6
Flag Post
HP Recommended

Thanks for sharing, I have seen these links and tried the solutions but none helped.

0 Kudos
Tags (1)
krzemien
Level 7
731 713 31 171
Message 4 of 6
Flag Post
HP Recommended

The suggestions in these (and only as I spotted few more) links is to liaise with HP Support on this.

AdnanMumtaz
Author
New member
3 2 0 0
Message 5 of 6
Flag Post
HP Recommended

I have found the ME Firmware is corrupted

 

Intel(R) MEInfo Version: 11.8.65.3590
Copyright(C) 2005 - 2018, Intel Corporation. All rights reserved.

 

FW Status Register1: 0x80032004
FW Status Register2: 0x30650152
FW Status Register3: 0x00000200
FW Status Register4: 0x00084000
FW Status Register5: 0x00000000
FW Status Register6: 0x40000000

CurrentState: Disabled
ManufacturingMode: Disabled
FlashPartition: Valid
OperationalState: Transitioning
InitComplete: Initializing
BUPLoadState: Success
ErrorCode: Disabled
ModeOfOperation: Temporary Disable mode
SPI Flash Log: Not Present
FPF HW Source value: Not Applicable
ME FPF Fusing Patch Status: ME FPF Fusing patch NOT applicable
Phase: BringUp
ICC: No valid OEM data, ICC programmed with default values
ME File System Corrupted: Yes
PhaseStatus: UNKNOWN
FPF and ME Config Status: Match

0 Kudos
Tags (1)
krzemien
Level 7
731 713 31 171
Message 6 of 6
Flag Post
HP Recommended

Just read your reports on another forums... good luck!

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation