cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New member
1 0 0 0
Message 1 of 2
235
Flag Post
HP Recommended

Omen Obelisk 4NM66AA#ABA - power on after power loss

Omen Obelisk 4NM66AA#ABA
Microsoft Windows 10 (64-bit)

Is it possible to enable auto-boot after a power loss on the Omen Obelisk desktop? I've booted into the BIOS to look for any boot settings or advanced settings that would enable it, but there doesn't seem to be an option. Am I missing something?

 

Thanks

1 REPLY 1
Highlighted
Level 12
Level 12
6,006 5,992 565 1,264
Message 2 of 2
208
Flag Post
HP Recommended

Omen Obelisk 4NM66AA#ABA - power on after power loss

Greetings,

Welcome to the forum.

I am not a HP employee.

 

This HP BIOS Support site (Link) may help you.

 

Look in:

 

BIOS Setup utility menus and settings,

Advanced,

Power-On Options,

After Power Loss.

 

I don't know if this setting enables auto boot after a power loss. Try enabling this to see if it works.

 

BTW, recurrent power failures are not good. Think about investing in an UPS to prevent operating system corruption and hardware damage.

 

Regards

 

 

 

0 Kudos
Be alert for scammers posting fake support phone numbers on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation