cancel
Showing results for 
Search instead for 
Did you mean: 
VWEthan
Level 1
8 5 0 0
Message 1 of 1
160
Flag Post

RAID Controller BIOS Boot Prompt never shows

HP Recommended
HP ENVY Phoenix Desktop - 860-160se CTO
Microsoft Windows 10 (64-bit)

I'm trying to configure the RAID configuration on a Vantec UGT-ST644R PCIe RAID controller.  This requires pressing CTRL-M at bootup when prompted, however, the HP ENVY Phoenix Desktop - 860-160se CTO I have never shows the Marvell BIOS prompt that is expected.  Instead, it goes right into Windows.  The only reason I am trying to do this is that the built-in RAID menu on the Pegatron board never shows even when the BIOS is set to RAID.  This system is also painfully slow at bootup - even with "Fast Boot" it takes a solid 90 seconds to show anything on the screen.  HP hasn't updated the BIOS since 2016.

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation