cancel
Showing results for 
Search instead for 
Did you mean: 
Samtheman19utd
New member
1 0 0 0
Message 1 of 2
153
Flag Post

Turn on the pc then it’s makes two long beeps and two short beeps a few times and then the led blink

HP Recommended
HP Pavillion i5 8GB/16GB Optane 2TB GTX1050Ti Gaming PC
Microsoft Windows 10 (64-bit)

When I boot up my pc it shows the HP logo then goes to the monitor no signal. A few seconds later there are two long beeps followed by two short beeps this repeats a couple times then the power LED flashes. I’ve left it for an hour because I read it could be the BIOs updating. This has happened a few  times now, the first time I held in the power button to turn it off then tried it again the next morning and it worked fine just took longer to boot up. I don’t want to keep repeating this. Any suggestions what this could be??

1 REPLY 1
Lil_Boy_Blue
Level 12
7,692 7,654 332 702
Message 2 of 2
Flag Post
HP Recommended

Hi

 

Perhaps this may help...

 

BIOS

2.22

The main area (DXE) of BIOS has become corrupted and there is no recovery binary image available. Also happens when updating BIOS.

Typically no steps needed.

1. Allow the system to complete its updates and changes.

2. If updates are stalling, attempt Sure Start Recovery.

 

 

https://support.hp.com/us-en/document/bph07107

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation