Create an account on the HP Community to personalize your profile and ask a question
09-07-2018 03:26 PM
My windows 10 wont boot up, i suspect after a Windows update
it says there are no windows restore points and i had several restores complted before this crash. I cannot do a factory restore either as it indicates there is NO Administrator account on the PC.
I loaded the "Windows 10 USB restore media" an it started fine but of course died at about 11%. I eventiually diiscovered that the media is looking to retore to partition 2 on the hard drive and I discovered my Windows partiition is on partition 3.
My question is: Does the HP Restore Media package reformat the entire hard drive so that it will actually reimage my hard drive?
Note: For some reason when I went into settings to select my system CD and the screen comes up saying "Press any key to select CD" the keyboard dont work. it works on every other thing I tried.
Fortunatly I had a USB DVD and thats how I got as far as I did with the above info. Also it went fine to the USB bootable media. My Partition 2 is the MSR Partition, partition 1 is the EFI partition partition 3 is the Primary.. The ONLY partition that would work with the Windows media Stick is partition 3, which fails, cause the Media is looking for Partition 2 only.
09-07-2018 04:18 PM - edited 09-07-2018 04:19 PM
In order to boot from a DVD you have to go into the BIOS enable legacy mode and disable secure boot.
See this guide for more info on that...
Yes, the HP recovery media will format the hard drive and restore the HDD to its 'out of the box' condition.
If you can't get the HP recovery media to work, you can always do this...
Since your PC came with Windows 10, you can do a clean install W10 for free by using the media creation tool at the link below.
The tool will allow you to make bootable installation media (USB/DVD) and you can use installation media to install.
For the USB flash drive you will need an 8 GB one.
W10 will install and then automatically activate once you are connected to the internet using the key embedded in BIOS of your machine.
Then you can install the drivers and available software you need from your PC's support page.
When you get to this window below, you may just want to delete all partitons, create one large partition and install Windows 10.
If you need to recover files from your old windows installation, then do not delete or format any partitions. Let W10 install over the current C:\Windows installation and it will create a Windows.old folder.
After W10 installs, you can browse the Windows.old folder, find your user profile, and copy the files from the old user profile to the new one.
I usually just copy all of the folders in my old user profile to the new one.
09-09-2018 12:28 PM
Thank you for your help. First thing I tried was downloading the Windows Tool after I discovered all of the recovery options all failed using the HP options. At that point all diags worked, and still do, I run the windows tool but it failed and the reason was the windows tool was looking for Disk 0, partition 2 to copy files too. I had 5 partitions all healthy, windows being partition 3 and that’s why the tool failed. I tried deleting EFI partition to make windows become partition 2, no good. I tried several senarios, none have worked. Then I tried deleting all partitions using the windows tool and making 1 large partition. The tool finished that and created 5 partitions again and OFC the windows partition was 3 (Primary) and the ONLY partition that could be selected and still it would not work. I give up for now and spent the near $50 to HP to get the Restore Disks sent to me and hopefully I can restore the PC to normal. Since I formatted the drive OFC now I do not have the option of going to Dos Command prompt so I have to wait now for the restore disks. So it goes ...