cancel
Showing results for 
Search instead for 
Did you mean: 
iwan12
New member
5 3 0 0
Message 1 of 2
662
Flag Post

hp z220 pxe boot fails e51

HP Recommended
HP Z220
When booting over the network HP z220 I get the error pxe-e51. although MS AD everything is OK, on another machine, z200 all goes well. Connected to the same switch. I tried on a pair of supermicro servers, also all is loaded. It is unclear why, after downloading your network card gets DHCP address fine. What could be the problem?
1 REPLY 1
jmarvin1
New member
1 1 0 0
Message 2 of 2
Flag Post
HP Recommended

I had this problem on a newer HP and found that PXE wasn't running long enough to get assigned the IP address. I found a place in the bios to extend the time to allow it to complete the process and then all worked fine. If you find it, document it because I am out looking for it again. If isn't easy to find in the BIOS

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation