cancel
Showing results for 
Search instead for 
Did you mean: 
barneyloiter
New member
1 0 0 0
Message 1 of 2
146
Flag Post

no response to power on key

HP Recommended
hp omni 120-1050xt cto desktop pc
Microsoft Windows 7 (64-bit)

no response to power button, replaced the adaptor no change. Green LED's on adaptor and on rear of unit next to where the power plug attaches are flashing when plugged in but adaptor's LED is solid green with no load.

Anyone recommend a carry in repair shop in Palm Beach County FL  ?

1 REPLY 1
Lil_Boy_Blue
Level 12
7,692 7,654 332 702
Message 2 of 2
Flag Post
HP Recommended

This will not work for everyone, but you may be lucky?


HP Notebooks and Mobile Workstations -
No Power, No Boot, No Display When Power Button Is Pressed



NOTE: Be sure the battery is installed in the computer and it has sufficient power before continuing. Due to the design of the Embedded Controller/Keyboard Controller, the power supply must be disconnected and the computer must be powered with battery power to reset the Embedded Controller/Keyboard Controller.

Unplug the AC power from the computer.
Press and hold the power button for more than 12 seconds.
Release the power button (after at least 12 seconds).
The computer will power on and should boot normally after releasing the power button.
Re-connect the AC power to the computer.

NOTE: In case the battery is not charging after performing the steps to reset the Embedded Controller, unplug and re-plug in the AC power again.

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation