reinstall the Bios because of error or slow start

[Lfete]

Hi there I want to know if there is a possibility to reinstall the Bios, -I could not find the Bios on the drivers and support, where can I find it ??

Thank you in advance

[Prométhée]

hi

check it

• Manufacturer's name: MSI
• Motherboard name: MS-7906
• HP/Compaq name: Orchid-S
• SSID: 2B17

https://support.hp.com/hk-en/product/hp-pavilion-500-300-desktop-pc-series/6879020/model/7298050

update available for windows 7 / 8 here

HP Consumer Desktop PC BIOS Update (ROM Family SSID 2B17)

80.16 Rev.A

5.9 MB

Apr 12, 2017

Download

[Lfete]

I did update the bios, but the pc still has this problems :

3F3 - Hard disk failure

slow start over 1 minute

not always load the programs fully or slowly.

I did try

reset Cmos (The 2 pins)

take the battery out of the motherboard

replace the ram (24GB ram/only 16 can be used)

defragment the drives

scan the drives for virus (found)

replace the C: drive with another SSD

update the Bios

Update DIAG.

Chk disk

reinstall MBR

rebuildBCD

I noticed when the PC have been on some hour it start to loose HD nr 2

any solution ? and thank you for the answer

[Prométhée]

hi

is that why you want the bios update?
rather you have a problem with your system disk...

You say you have changed the SSD disk, except, it is a particular system, see the discussion here

https://h30434.www3.hp.com/t5/Desktop-Operating-Systems-and-Recovery/Verifying-that-replacement-SSD-...

if it is the same thing, than not configured, then it is possible that this replacement is useless, and in this case it is the HDD disk, which is having problems..
but I don't know more about what you did exactly? ..

https://support.hp.com/hk-en/product/hp-pavilion-500-300-desktop-pc-series/6879020/model/7298050/doc...

hdd 1 TB

16 GB Disk Caching solid state drive

please perform the hardware tests
everything is explained in this link

HP PCs - Testing for Hardware Failures | HP® Customer Support

you may have an error code , failure ID (24-digit code) , as shown

if so, just give this code here