• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
HP Recommended
Pavilion
Microsoft Windows 10 (64-bit)

I updated my Intel optain 16g to 32. I have 4tb ssd hard drive but after I updated optain started my computer I get that there is no os. It should be on my ssd 

1 REPLY 1
HP Recommended

Greetings,

Welcome to the forum.

I am not a HP employee.

 

Have to make this assumption: Your PC shipped from HP with the 16 GB Optane drive and your motherboard (MB) supports Optane (Intel Gen 7 or higher). The HP factory image supports an Optane configuration.

 

The new 32 GB Optane drive is blank. The PC should load Windows if no Optane drive is installed. The boot loader should be on the slower HDD.

 

You will either have to create a system image of the factory setup with the 16 GB drive installed and then physically install the 32 GB drive and reimage the new drive config or install the factory image to the new drive config.

 

Imaging the new config preserves data and system image. Reinstalling the factory image destroys data and the current setup.

 

Your call.

 

Regards

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.