Post new question
Question
Reply
 
Top Student
Posts: 5
Member Since: ‎07-31-2014
Message 1 of 2 (305 Views)
Accepted Solution

Opening the back cover of the hp Pavilion 23-f250 desktop all-in-one

Hi TwoPointOh

 

I appreciate letting me know step by step process of the opening the back cover of the NEW (2013) hp Pavilion 23-f250 desktop all-in-one to add ram memory. There are some video online but not for 23-f250, is there one for thins one?

 

Thanks

Reply
0
Accepted Solution

Re: Opening the back cover of the hp Pavilion 23-f250 desktop all-in-one

Hi,

 

Try this HP Upgrade and Servicing Guide.

 

Memory Modules removal

Before you begin: Remove the VESA cover and the rear cover.

Steps

  1. Carefully pull out the EMI shield covering the memory slots – take care not to damage the battery on the motherboard.
  2. Next, gently pull out on the retaining lever located on each side of the SO-DIMM memory module.  The module will pop up from its socket.
  3. Pull the module out of the socket.

Memory Modules replacement

 

Steps

  1. There is a small notch on one side of each SO-DIMM module that fits over a small tab on one side of each SO-DIMM socket.
  2. To replace an SO-DIMM memory module, angle the module to about 45 degrees, engaging the notch into its socket tab.
  3. Press the module down into place until the retaining levers snap into position over the sides of the module.
  4. Carefully align the top edge of the EMI shield over the memory slot cutout on the motherboard shield – then press it down into place.
View solution in context
Provost
Posts: 25,870
Member Since: ‎07-17-2009
Message 2 of 2 (294 Views)

Re: Opening the back cover of the hp Pavilion 23-f250 desktop all-in-one

[ Edited ]

Hi,

 

Try this HP Upgrade and Servicing Guide.

 

Memory Modules removal

Before you begin: Remove the VESA cover and the rear cover.

Steps

  1. Carefully pull out the EMI shield covering the memory slots – take care not to damage the battery on the motherboard.
  2. Next, gently pull out on the retaining lever located on each side of the SO-DIMM memory module.  The module will pop up from its socket.
  3. Pull the module out of the socket.

Memory Modules replacement

 

Steps

  1. There is a small notch on one side of each SO-DIMM module that fits over a small tab on one side of each SO-DIMM socket.
  2. To replace an SO-DIMM memory module, angle the module to about 45 degrees, engaging the notch into its socket tab.
  3. Press the module down into place until the retaining levers snap into position over the sides of the module.
  4. Carefully align the top edge of the EMI shield over the memory slot cutout on the motherboard shield – then press it down into place.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation