12-06-2018 10:33 AM
I am able to successfully apply my BIOS settings using a BCU config fie but I am unable to disable the Legacy Boot Sources using the BCU. I initially set the bios settings the way I want them including disabling Legacy Boot Sources and then captured my bios config file using the command line tool. I then go back into bios and set factory defaults/bios defaults so that I can test my new config file is working as expected. While all of the other settings are applied successfully using the BCU, Legacy Boot Sources remain active. I cannot disable them via BCU. Everything under Legacy Boot Order in the config file says Disabled. I'm not sure what else to try. Has anyone else ran into this scenario?
Solved! Go to Solution.
12-06-2018 01:09 PM
this might not the best forum for your workstation related question, you might get better responce from the workstation forum