• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
We have new content about Hotkey issue, Click here to check it out!
Check out our WINDOWS 11 Support Center info about: OPTIMIZATION, KNOWN ISSUES, FAQs, VIDEOS AND MORE.
Locked

‎10-25-2018 02:03 AM

HP Recommended
Product: Pavillon all-in-one
Operating System: Microsoft Windows 10 (64-bit)

It just wont boot up. It beeps 3 then 4 beeps and shuts down

1 person had the same question
3 REPLIES 3

‎10-25-2018 05:33 AM - edited ‎10-25-2018 05:34 AM

HP Recommended

That sequence on AIO sometimes is caused by a loose power cord.  Check the power cord connection by disconnecting and then reconnecting.

 


I'm not an HP employee.
Did this message answer your question? Please indicate below as an Accepted Solution!
Did you find this message useful? Click on the "Was this reply helpful" Yes button.
Was this reply helpful? Yes No

‎10-25-2018 06:46 AM

HP Recommended

Appreciate your comments but no it did not help. I dont understand what to do because Ive done everything all the HP hints say to do.

Is it serious problem.

Was this reply helpful? Yes No

‎10-25-2018 07:56 AM

HP Recommended

Well, if that does not fix the problem, the beep codes are a crude way to tell the user there has been a hardware failure.  For a user to fix a AIO, is not quite as easy as a desktop.  You might need some help.  Most probable cause for a failure when the PC was working previously is a memory fault.  Try running the diagnostics from the esc menu.  Start tapping on the Esc, then press the start (power) button.  Pick diagnostic from the popup menu.


I'm not an HP employee.
Did this message answer your question? Please indicate below as an Accepted Solution!
Did you find this message useful? Click on the "Was this reply helpful" Yes button.
Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.