• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Locked

‎10-09-2022 01:04 PM

HP Recommended
Product: HP ENVY Desktop - TE01-1022
Operating System: Microsoft Windows 11

It took me a few months to find the correlation but it reliably repros that every time my HDD stops spinning, the secondary VGA port connected monitor starts blinking (going black for 2-3 seconds then coming back on for a little while before going black again).  The workaround I have is to open Windows explorer and navigate to a folder on the secondary drive (HDD, the primary is SDD) so it starts spinning again.  Then the flickering stops until the drive stops spinning again.

 

This is pretty annoying.  Is there any permanent solution for this?

 

I have rebooted, updated drivers, factory reset the monitor, tried sleep settings (display and device never go to sleep) to no avail.

 

Thanks for your help!

Category:
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.