cancel
Showing results for 
Search instead for 
Did you mean: 
radar232
New member
2 0 0 0
Message 1 of 1
162
Flag Post

Z31X StudioDisplay takes very long time to wake up from standby

HP Recommended
HP Z31X
Microsoft Windows 10 (64-bit)

My Z31X StudioDisplay takes very much time to wake up from standby. The Screen is black and showing the status message:

 

Input Signal not found.

Check the video cable on scource.

Display going to sleep.

 

My second monitor connected to the computer immediately shows windows screen after waking up the computer from standby.  Sometimes if the second monitor is switched off, the HP Z31X wont wake up at all, so that I have to switch on the scond monitor and if done that, the Z31X also wakes up. It's very annoying. A mate has the same monitor and it has the same behaiviour.

 

I hope there will be a firmware update to fix this solution.

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation