cancel
Showing results for 
Search instead for 
Did you mean: 
m3th0dddm4nx
New member
1 0 0 0
Message 1 of 2
472
Flag Post

my hp 2011x power button doesn't light up

HP Recommended
Unknown

41FCHvepYzL._SR600,315_PIWhiteStrip,BottomLeft,0,35_SCLZZZZZZZ_.jpg.

hi guys picture has been attached when i turn on my monitor the power button doesn't light up, to let me know the monitor is on... is there a fix for this or is this garbage now?

1 REPLY 1
TEJ1602
HP Support Agent
HP Support Agent
18,899 18,877 1,560 1,570
Message 2 of 2
Flag Post
HP Recommended

@m3th0dddm4nx, Welcome to HP Support Community!

 

 Turn on the computer and complete the following steps:

 

Step 1: Check cable connections

 

If you can see the initial HP or Compaq logo screen but later lose the picture, you can skip to Step 2.

Otherwise, check the video cable connection on the back of the computer and on the monitor. Make sure that it is connected properly and the connecting screws are tight. Turn the monitor off and then back on again (while the computer is on) to see if an image appears.

Some Flat Panel monitors have two similar power input connections placed side-by-side on the back of the monitor, which sometimes allows them to get confused for one another. One connector is used to supply power to the speakers with a separate power cord, while the other connector is used for the monitor's power adapter.

Ensure that you have the monitor power adapter cord plugged into the power connector and not the speaker connector.

After you have reconnected the power cord, turn on the monitor (while the computer is on) to see if an image appears. If there is still no image, continue to the Next Step.

 

Step 2: Resetting the monitor

 

At first setup, or under certain signal conditions, the monitor may not be able to switch to a new display resolution. Do NOT shut down or restart the computer. Instead, perform the following steps:

  1. Turn off the monitor using the Power button on the front.

  2. If the Power button does not respond, unplug the power cord from the back of the monitor and wait five seconds.

  3. Plug the power cord back in.

    You should see the image from the computer on the screen.

Refer to this document for help.

 

Keep me posted.

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

TEJ1602
I am an HP Employee

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation