Create an account on the HP Community to personalize your profile and ask a question
01-07-2020 07:41 AM
I just set up my printer via wifi and all connections are good. Test page prints. however, the printer is not showing ready on the laptop all the time, it shows off-line. I check the settings and reprint a test page and all is passing, but Why is the printer showing off-line?
01-09-2020 11:32 AM
Welcome to HP support community.
Use HP Print and Scan Doctor to check connectivity
Download HP Print and Scan Doctor.
Run HPPSdr.exe from the download location on your computer.
Once HP Print and Scan Doctor opens, click Start, and then select your printer.
If your printer in not in the list, turn it off and on, and then click Retry.
If there is a connection problem, follow the instructions in HP Print and Scan Doctor.
If a screen prompts you to turn on printer updates, click Yes.
If a screen prompts you to make your printer the default printer, click Yes.
Try to print.
Assign manual IP address and that should fix the issue.
Check the network configuration or print the wireless test report
1. From the Home screen, touch (Wireless) and then touch Settings.
2. Touch Print Reports. and then touch Network configuration Page or Wireless Test Report.
Setting a Static IP Address
Once you know your printer’s IP address, entering it is pretty easy. Here’s what you do:
- Run your Web browser.
- In the Web browser’s address bar, type the IP address of your printer and press Enter. Assuming you entered the right address, the HP printer control panel should appear.
- Click the Networking tab.
- Under Connections, click Wireless.
- Under IP Address Configuration, click Manual IP.
- Enter the IP address, subnet mask, and default gateway in the appropriate boxes.
- Click Apply.
You can refer this HP document for more assistance:- Click here
Let me know how it goes.
To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.
I am an HP Employee
Didn't find what you were looking for? Ask the community