The HP Community is here for you.
02-27-2012 07:13 AM - edited 02-27-2012 07:15 AM
Can I get assistance on the following trouble with my desktop ?
D530 (CMT) motherboard with SATA HDD (160 GB ) -After loading Win 7 (32 bit), getting blinking cursor on black screen only if I do warm boot. The screen just stuck there and will not progress to anywhere after that. During cold boot, the OS loads fine. Also while BIOS loading screen, there is a message flash "press any key for ROM options" whenever this SATA HDD is connected to the motherboard. There is no issue with Win7 booting if I load it on a IDE hard disc with the same motherboard. Tried upgrading BIOS from v1.11 to 2.44 and still no luck. Pls advise.
02-27-2012 08:05 AM - edited 02-27-2012 08:06 AM
See if clearing the CMOS helps.
To do that, shut down the PC, unplug everything connected to it...power cord, keyboard, monitor, mouse --everything.
Open the case and near the coin cell battery there is a little yellow button.
Push and hold it in for 30 seconds.
Put everything back together and hope that works. You will need to go into the BIOS and set the date and time.
Did the 160 GB SATA hard drive work OK when you had XP on it?
I only went up to a 120 GB SATA in my d530. Wasn't sure it would take more than that.
Did you install a windows 7 capable AGP video card?
If not, your graphics is not going to work under windows 7, unless you read this post and install the driver listed in the green shaded solution post from PhilBene.
03-01-2012 08:56 AM
Clearing of CMOS didn't help. I installed Win 7 on the SATA disc and it works fine when I cold start. The issue is only when I restart (warm boot) it. So the system detects this SATA drive.
I haven't tried loading Win XP on this SATA drive and test in fact.
Also there is a nVidia graphics card (Quadro4 750XGL) installed on the AGP slot.
The Win 7 works fine with another 20 GB IDE hard disc without any cold/warm reboot issues ! So I guess there is something wrong with D530 -Win 7 -SATA Drive combination. Pls advise.
RAM size 1 GB.
Thanks & Regards,
03-01-2012 09:00 AM
Also I tried copying those driver files to C:\Windows\system32 folder as mentioned by PhilBene and still not working.
03-01-2012 09:01 AM
I don't know why that is happening to you.
I installed W7 on my d530 CMT that had a Samsung 120 GB SATA drive and had no issues at all with the BIOS storage controller option set to the default of "add as separate controller."