The HP Community is here for you.
01-20-2014 10:07 AM
Good morning to whomever can help me.
I have recently purchased a HP Envy 700-074 Desktop computer (12/31/13) with Windows 8 and have had several issues with it (thankfully I have been able to resolve them myself so far).
I however, have been trying to install a new Huion H580 graphics tablet onto this computer. I go through the installation of the provided CD and after restart, attemp to plug in the tablet. I get an error that pops up in the lower right corner of the screen saying the driver malfunctioned and is not recognised.
I do not have another computer with Windows 8 on it to attempt installing this new device, but from doing some digging around and attempting a few things listed on HP's website (uninstalling USB drives then restarting the computer to reinstall them, which ultimately led to my whole system crashing, use of the recovery set brought me back to a fresh slate)(Granted I can't be sure that was the exact reason, or if it was bound to happen with this computer). I have found that I can get the program for the tablet to open very briefly, it flashes on the desktop screen, but shuts down so fast that it doesn't even pop up in task manager. I found also that the device is listed with a Code 43 and is being blocked from use, is there a setting I can change to allow this hardware to be used?
I really would like to be able to install this device as I am working on designs in Adobe programs, which are much easier with the graphic tablet.
I would greatly appreciate any help, I've already lost all designs I have previously made because I foolishly saved them to my desktop prior to the crash. (I also didn't have anything big enough to back my files up to, I will for sure be saving things to the cloud from here on out!)
Thank you to whomever can help!
01-20-2014 06:56 PM
Unplug the device from your PC and reboot. At the Start screen type Troubleshooting
Next select Hardware and Sound then Hardware and Devices. If Windows finds and corrects the problem then reboot your PC.
Now go into Device Manager (Windows key +x) and make sure that all of the Universal Serial Bus Controllers are operating correcting.
Plug the device into a USB 2 port (non blue tab). If you still have problems then review this article.
HP Photosmart 6520 and HP Deskjet 1112
Custom 1151 socket Z270 Intel i7-7700k @4,600 Mhz, 16GB Corsair 3000 Mhz dimms
Corsair H75 water cooler, Corsair CS 650M power supply
RAID 0 (dual Samsung 960 EVO m.2 240GB) boot system
Dual Samsung 840 EVO SSDs 500GB data storage, Intel 750 PCIe SSD 400GB
MSI NVIDIA GTX 980TI 6GB
ASUS ROG PG279q @144 MHz
Windows 10 and Windows 8.1 Pro x64 in UEFI mode