cancel
Showing results for 
Search instead for 
Did you mean: 
DavidWAMPS
New member
1 0 0 0
Message 1 of 2
1,988
Flag Post

New RAM, Omen doesn't show

HP Recommended
HP Omen dh-1088nr
Microsoft Windows 10 (64-bit)

I've replaced both ram sticks with two 8gb (16gig total) RAM DDR4. When I open Omen Command Center, it says I still only have 8gb RAM.
How do I update this/ change it?

 

I've uninstalled the Command Center and reinstalled, it is updated.

1 REPLY 1
banhien
Level 19
Level 19
92,651 92,529 11,972 25,533
Message 2 of 2
Flag Post
HP Recommended

@DavidWAMPS 

 

Firstly please re-seat RAM properly then check again. If problem persists, please try

  • Press and Hold the Windows key and Press R. Type msconfig in the Run dialog box and Press Enter.
  • The System Configuration window will open. Go to the Boot tab in it.
  • Select your Operating system from the list below if you have more than one. Now Click on the Advanced Options button.
  • On the upper right corner, Clear the checkbox next to Maximum memory. Click Ok.

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.



0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation