Web Services could not be connected to printer

[Cindy-Who]

I’m getting this message on our printer, “Web Services could not be set up at this time.  The printer will try again later. Note: Instant Ink will not work properly unless Web Services is set up.”

I noticed we were getting ink mailed through the Instant Ink program.  I have reset the printer to factory settings and reconnected the Wi-Fi.  Still getting this message.  

[A_Gayathri]

Hi @Cindy-Who,

Welcome to the HP Support Community

I understand you are facing an issue with your HP OfficeJet 5252 All-In-One Printer. Not to worry I will help you to get a resolution to resolve the issue.

Let's perform a power drain: 

• With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.
• Remove the USB cable, if present.
• Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.
• Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer.
• Turn on the printer and wait till the warm-up period finishes and the printer is idle

Update the printer firmware 

• Click here to download and install the latest printer firmware from your product
• Click here to know different methods of updating the printer firmware.

If the issue persists, then please follow the steps mentioned in this document: HP printers - Cannot connect to Web Services

Hope this helps! Keep me posted. 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

[A_Gayathri]

Hi @Cindy-Who,

Welcome to the HP Support Community

I understand you are facing an issue with your HP OfficeJet 5252 All-In-One Printer. Not to worry I will help you to get a resolution to resolve the issue.

Let's perform a power drain: 

• With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.
• Remove the USB cable, if present.
• Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.
• Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer.
• Turn on the printer and wait till the warm-up period finishes and the printer is idle

Update the printer firmware 

• Click here to download and install the latest printer firmware from your product
• Click here to know different methods of updating the printer firmware.

If the issue persists, then please follow the steps mentioned in this document: HP printers - Cannot connect to Web Services

Hope this helps! Keep me posted. 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!