cancel
Showing results for 
Search instead for 
Did you mean: 
Common problems for INSTANT INK, HP+ PLANS: INK AND TONER
We would like to share some of the most frequently asked questions about Instant Ink. Check out this link: HP INSTANT INK, HP+ PLANS: INK AND TONER. .
Lauralb1
New member
1 0 0 0
Message 1 of 2
104
Flag Post

printer wont print

HP Recommended
hp deskjet 2630

Hi our printer is saying its off line and isn't connected to the internet, the internet wireless button is flashing and so is the I button. We have followed all steps via the virtual agent and none have worked. We have also reconnected the internet, switched both off etc and still its saying off line. Any ideas?? Thanks

1 REPLY 1
Kumar0307
HP Support Agent
HP Support Agent
20,419 20,421 1,491 1,739
Message 2 of 2
Flag Post
HP Recommended

Hi @Lauralb1

Welcome to the HP Support Community. I'd be happy to assist you.

 

If the wireless button is flashing, it means the printer is not connected to the network. Let us try these steps to resolve this issue:

 

Reset the printer

  1. With the printer turned on, disconnect the power cord from the rear of the printer.
  2. Wait at least 60 seconds.
  3. Reconnect the power cord to the rear of the printer.
  4. Turn ON the printer, if it does not automatically turn on.
  5. Wait until the printer is idle and silent before you proceed.

Note: HP recommends connecting the printer directly to a wall outlet rather than a surge protector or a power strip.

 

Restore network settings:

Press and hold the Wireless button and the Cancel button from the printer control panel together for three seconds.

 

Once done, Use WPS to connect the printer to your wireless network.

  1. Locate the WPS button on your router, but do not press it yet.

    If your router does not support WPS, skip to the next step to connect the printer with the HP Smart app.

  2. Turn on the printer. If the printer is in sleep mode, press the Cancel button on the control panel.

  3. On the printer control panel, press and hold the Wireless button  for at least 3 seconds or until the wireless light starts to flash.

  4. On the router, press and hold the WPS button for 3 to 5 seconds or until it shows that the WPS connection process has started.

    NOTE: The printer stops searching for a WPS connection two minutes after the wireless button is pressed. If you were unable to press the WPS button within that timeframe, attempt these steps again.

    Once the printer connects to the wireless network, the blue Wireless light on the control panel turns on solid.

  • Make sure the printer and the PC are connected to the same wireless network.
  • This printer supports only 2.4GHz network. So, the PC should be on the 2.4GHz network.
  • If you have a Dual-band router and both 2.4GHz and 5GHz networks share the same name/SSID, the printer will not be able to connect to the network. In this case, contact your Internet service provider to assign different names to both the networks.

For more info on blinking lights, refer to this document.

 

Hope this helps! Keep me posted. 

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!

Have a great day! 

KUMAR0307
I am an HP Employee

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation