cancel
Showing results for 
Search instead for 
Did you mean: 
ollie81
New member
1 0 0 0
Message 1 of 2
527
Flag Post

HPRGS not fitting sender screen properly

HP Recommended
HP ZR2240w
Microsoft Windows 10 (64-bit)

 

I am trying to setup HPRGS on a HP Z420 desktop.
I am using version HPRGS 7.6
The issue is that after starting the receiver on my windows 10 pc, and getting connected to the Z420, I cannot make the RHEL desktop fit the PC's monitor properly. I can't see the bottom of the desktop, which means I can't see the RHEL taskbar. How can I make the screen fit my monitor? The monitor attached to the Z420 is a HP ZR2440w 24", while the PC has an attached HPZR2240w 22" monitor.  I am using RHEL 7.5 on the Z420 and have Windows 10 on the PC.  I am hoping that it is possible to use a couple of different PC's with various size monitors to connect to this Z420.  I have a NVIDIA Quatro K4000 graphics card in the Z420

Thanks for any help.

1 REPLY 1
KellyRGS
Level 7
Level 7
541 534 41 51
Message 2 of 2
Flag Post
HP Recommended

What resolution are you trying to match on your receiver?  Are you checking match resolution and layout on the receiver GUI?  Also, I have attached the user guide for RGS 7.6.0, please look at Page 41 where we discuss display resolution and layout with a Linux sender.

I am an HP employee.
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation