cancel
Showing results for 
Search instead for 
Did you mean: 
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
Jovan3
New member
4 2 0 0
Message 1 of 3
481
Flag Post

Solved!

Zcentral remoteboost and firewall

HP Recommended
Microsoft Windows 10 (64-bit)

Hi,

This has probably been asked before. To be able to communicate between reciever and sender the port 42966 must be open in firewall. But is it only TCP port or even UDP?

/Jovan

1 ACCEPTED SOLUTION

Accepted Solutions
KellyRGS
Level 7
Level 7
696 686 53 68
Message 2 of 3
Flag Post
HP Recommended

I normally recommend that port 42966 is open on both TCP and UDP.  HP Velocity is enabled by default, and when activated it will change the TCP traffic to UDP.  Make sure your network has UDP enabled.

I am an HP employee.

View solution in original post

Was this reply helpful? Yes No
2 REPLIES 2
KellyRGS
Level 7
Level 7
696 686 53 68
Message 2 of 3
Flag Post
HP Recommended

I normally recommend that port 42966 is open on both TCP and UDP.  HP Velocity is enabled by default, and when activated it will change the TCP traffic to UDP.  Make sure your network has UDP enabled.

I am an HP employee.

View solution in original post

Was this reply helpful? Yes No
Jovan3
Author
New member
4 2 0 0
Message 3 of 3
Flag Post
HP Recommended

Hi Kelly,

Ok, thanks for the information!

BR

Jovan

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation