cancel
Showing results for 
Search instead for 
Did you mean: 
rademarco7
New member
1 0 0 0
Message 1 of 2
61
Flag Post
HP Recommended

Blue is not printing and i have cleaned and alligned

officejet 6962

I have the officejet6962 replaced cartridges and now the blue is not printing I have run maintance, cleaned heads clean smear and align carttridges it will not scan alignment either I think because its missing color

 

1 REPLY 1
HP Support Agent
HP Support Agent
17,062 16,974 962 1,083
Message 2 of 2
16
Flag Post
HP Recommended

Blue is not printing and i have cleaned and alligned

@rademarco7

 

Welcome to HP support community.

 

Make sure the ink cartridges are properly vented and seated correctly

  1. Turn on the printer, if it is not already turned on.

  2. Open the ink cartridge access door.

    The carriage moves to the center of the printer.

    Open the cartridge access door

  3. Wait until the carriage stops moving before you continue.

  4. Press the tab inward on the front of the old ink cartridge to release it, and then pull up on the ink cartridge to remove it from the slot.

    Pushing the ink cartridge inward and then pulling up to remove it

  5. Examine the vent area above the HP logo on the top of the ink cartridge.

    Image: Examine the vent area on the top of the cartridge

  6. If the ink cartridge still has the orange pull-tab attached, pull to remove it.

    Image: Remove the orange pull-tab

  7. If the vent is clogged, use a straight pin to gently remove excess adhesive from the vent.

    1.  

      Clogged vent
    2. With a straight pin, gently remove excess adhesive from the vent

    3. Unclogged vent

  8. Turn the ink cartridge so that the ink cartridge contacts face downward, and then match the label color with the color dot on the carriage.

  9. Slide the ink cartridge into its slot, and then gently press the ink cartridge down until it snaps into place.

    Reinserting the ink cartridge

  10. Repeat these steps to inspect the vents on each of the ink cartridges.

  11. Make sure each ink cartridge is firmly installed in its slot. Run your finger along the top of the ink cartridges to feel for any that are protruding, and if any are, press down firmly until each ink cartridge snaps into place.

  12. Close the ink cartridge access door.

    Closing the ink cartridge access door

You can refer this HP document for more assistance:- Click here

 

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

Reply
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation