Can't install my printer

[vanni177]

I can't install my printer.

I can see the IP for LAN and W-LAN in the display, but can't connect to it.

Also not by USB connection.

The same thing for Mac and Windows.

I can see the printer IP in the routers network-list.

The EWS is also not working.

Any ideas?

[sandytechy20]

@vanni177

Welcome to HP support community.

Perform a power reset

1. Turn on the printer, if it is not already on.
2. Wait until the printer is idle and silent before you continue.
3. With the printer turned on, disconnect the power cord from the rear of the printer.
4. Wait at least 30 seconds.
5. Plug back the power cable straight to a wall outlet without any surge protector and printer.
6. Turn on the printer.

Update the printer firmware

Refer this HP document for the steps to update firmware:- Click here

Restore the printer to the original network settings

1. From the printer control panel, touch and slide your finger across the screen, touch Setup, and then touch Network Setup.

2. Touch Restore Network Defaults, and then touch Yes. A message appears stating that the network defaults have been restored.

3. Touch OK.

4. Print the network configuration page and verify that the network settings have been reset.

Set up the printer on your wireless network again

1. From the printer control panel display, touch and slide your finger across the screen and then touch Setup.

2. Touch Network Setup.

3. Touch Wireless Settings.

4. Touch Wireless Setup Wizard.

5. Follow the display instructions to complete the setup.

Let me know how it goes.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.