• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.

‎07-14-2020 05:42 PM

HP Recommended
Product: Hp photosmart 5510
Operating System: macOS 10.12 Sierra

After cleaning the print head, the carriage is slamming into the right side and causing a cartridge jam.

I can confirm this issue is caused by the print head being installed incorrectly after cleaning. Open it back up and notice the purple-ish ribbon running along the back of the print head with a black dot and triangle indicator on the right side of the ribbon. If you inspect the ribbon closely, you'll see it is somewhat textured with lines running up and down the ribbon every millimeter or so (I didnt didnt measure them, there are tons). This ribbon is encoded to communicate to the print head what its' current position is. Now look at the back side of the print head, and you will note the ribbon reader in the middle of the print head between the 2 retaining springs. The ribbon will almost naturally sit inside the ribbon reader within the lower slot. That is wrong. The ribbon must sit in the upper slotted section, which will take a little fiddling. Be careful not to damage the ribbon, if it is damaged, there is no repair, it will cause errors in print accuracy, and the ribbon will need replacing. I know the previous posters of this issue recycled their unit and got a new printer, which is disappointing, since it was a simple mistake, which would have taken 5 minutes to correct. Hope this helps someone out there! 

Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.