cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New member
2 0 0 0
Message 1 of 2
64
Flag Post
HP Recommended

Duplex printing misaligned

Hp envy 4520
Microsoft Windows 10 (64-bit)

I am printing using copier paper at 90gsm if i am not wrong. I tried duplex printing, but each time it will misaligned  2nd page top left misaligned by -0.9mm. Bottom left by -1mm.

 

kindly help. I browse through the solutions and tested but it does not work for me. 

1 REPLY 1
Highlighted
HP Support Agent
HP Support Agent
19,196 19,099 1,095 1,181
Message 2 of 2
23
Flag Post
HP Recommended

Duplex printing misaligned

@Haily

 

Welcome to HP support community.

 

Perform a power reset

  1. Turn on the printer, if it is not already on.
  2. Wait until the printer is idle and silent before you continue.
  3. With the printer turned on, disconnect the power cord from the rear of the printer.
  4. Wait at least 30 seconds.
  5. Plug back the power cable straight to a wall outlet and printer without any surge protector.
  6. Turn on the printer.

Update the printer firmware

Here are the steps:- Click here

 

Try the duplex printing again

You can refer this HP documents:- Click here

 

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

Reply
0 Kudos
Be alert for scammers posting fake support phone numbers on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation