Instant ink service cancelled and now i can't print

[yalis]

I had the HP instant ink service for a while then cancelled. Billing stopped. However, i bought a ink cartridge from the store and have not been able to print. Instead I keep getting a message requesting that I renew my subscription. This feels like a scam. They encourage you to sign up and then when you opt out, they hold your printer hostage. 

[TEJ1602 · Accepted solution]

@yalis, Welcome to HP Support Community!

Follow the steps below to isolate and resolve the issue-

Reset the printer

1. Turn the printer on, if it is not already on.
2. Wait until the printer is idle and silent before you continue.
3. With the printer turned on, disconnect the power cord from the rear of the printer.
4. Unplug the power cord from the wall outlet.
5. Wait at least 60 seconds.
6. Plug the power cord back into the wall outlet.
7. Reconnect the power cord to the rear of the printer.
8. Turn on the printer, if it does not automatically turn on.
9. Wait until the printer is idle and silent before you proceed

Update the printer firmware

Download available firmware updates from the HP website

With the printer on and connected to the computer, go to HP Customer Support - Software and Driver Downloads, and then identify your printer. Look for and install any available firmware updates. Refer to the document HP Printers - Updating or Upgrading Printer Firmware

Try these steps to re-enable the web-services -

Step 1 Remove the Web-Services 

1. From the top of the screen, touch or swipe down the tab to open the Dashboard, touch ( HP ePrint ), and then touch (Web Services Settings).

2. Touch Remove Web Services.

Reboot the devices.

Step 2 Enable the Web-Services 

1. From the top of the screen, touch or swipe down the tab to open the Dashboard, and then touch ( Setup ).

2. Touch Web Services Setup .

3. Touch Accept to accept the Web Services terms of use and enable Web Services.

4. On the screen that appears, touch OK to allow the printer to automatically check for product updates.

5. If the Printer Update Options screen is displayed, select one of the options.

6. When the printer is connected to the server, the printer prints an information page. Follow the instructions on the information page to finish the setup.

Hope this helps! Keep me posted. 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

[yalis]

Sorted!

Thanks