OJP 8025 alignment issue

[RitaL50]

I have a demo printer stuck in alignment mode. Wont clear, but never prints the alignment  page

[The_Fossette]

@RitaL50,

Welcome to the HP Support Community!

I reviewed your post and I understand that you are getting an alignment error on the printer.

Don’t worry, I assure you I will try my best to get this sorted.

I recommend you follow the steps in the below article and check if it helps.

https://support.hp.com/us-en/product/hp-officejet-pro-8020-all-in-one-printer-series/24208622/model/...

Let me know how it goes and you have a great day!

If you wish to show appreciation for my efforts, mark my post as Accept as Solution. Your feedback counts!

Cheers!

[The_Fossette]

@RitaL50,

I understand that the printer is stuck on the alignment process and you are unable to complete the alignment process. Is that right? If yes, then follow the steps suggested in the article and check if it helps.

If the alignment process is successful then follow the below steps.

1. With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet. 
2. Remove USB cable, if present. 
3. Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge. 
4. Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer. 
5. Turn on the printer and wait till warm-up period finishes and the printer is idle.

If you continue facing the issue then update the printer firmware following the steps in the below article.

https://support.hp.com/us-en/document/c02919168

If you wish to show appreciation for my efforts, mark my post as Accept as Solution. Your feedback counts!

Cheers!