Printer head jam

[Arnold1950]

The printer head will not move to the center when I open the carriage access door on my HP Photosmart C6380 after I change on of the ink cartridge.

[sandytechy20]

@Arnold1950

Welcome to HP support community.

Perform a power reset

1. Turn on the printer, if it is not already on.
2. Wait until the printer is idle and silent before you continue.
3. With the printer turned on, disconnect the power cord from the rear of the printer.
4. Wait at least 30 seconds.
5. Plug back the power cable straight to a wall outlet and printer without any surge protector.
6. Turn on the printer.

Check for obstructions in the carriage path

1. With the printer on, disconnect the power cord from the rear of the printer.

2. If your printer has a battery, remove the battery.

3. Open the door to access the carriage inside of the printer.

   Examples of carriage access doors

   

4. Look in the carriage path for debris such as crumpled paper or dislodged labels, and then remove any that you find.

   Example of a printer with debris in the carriage path

   

5. If the carriage on your printer has a latch, make sure it is closed

6. Use your hand to move the carriage to each side, making sure it moves freely. If the carriage is stalled or docked to one side of the printer and you cannot move it, continue with these steps.

7. Close the carriage access door.

8. Reconnect the power cord to the rear of the printer, and then turn the printer on.

You can refer this HP support community for more assistance:- Click here

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.