cancel
Showing results for 
Search instead for 
Did you mean: 
Theoldman8
New member
1 0 0 0
Message 1 of 2
50
Flag Post
HP Recommended

Printing

Photosmart6525

I was printing on my photosmart 6525 all in one, the black cartridge ran out of ink I replaced the cartridge and  now its not printing. I don’t get any errors massages everything seems to be working as normal. Did clean the heads but with no prevail.

1 REPLY 1
HP Support Agent
HP Support Agent
18,503 18,411 1,057 1,157
Message 2 of 2
18
Flag Post
HP Recommended

Printing

@Theoldman8

 

Welcome to HP support community.

 

Check the ink cartridge vents

  1. Open the ink cartridge access door.

    Open the cartridge access door

  2. Press the tab on the front of the ink cartridge to release it, and then pull it out of the slot.

    Remove the cartridge from the slot

  3. Examine the vent area on the top of the ink cartridge.

    Vent area on the top of the ink cartridge

  4. If the vent is clogged, use a pin to gently remove excess adhesive from the vent.

    1. Clogged vent

    2. Gently remove excess adhesive from the vent

    3. Unclogged vent

  5. Make sure the orange pull tab is completely removed.

    Orange pull tab on the ink cartridge

  6. Insert the ink cartridge into its slot. Press down until it snaps into place.

  7. Repeat these steps for any other ink cartridges with defects on the report.

  8. After reinserting all the ink cartridges, run your finger along the top of the ink cartridges. If any are protruding, press down firmly until each ink cartridge snaps into place.

You can refer this HP document for more assistance:- Click here

 

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

Reply
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation