cancel
Showing results for 
Search instead for 
Did you mean: 
Zee22
New member
1 0 0 0
Message 1 of 2
113
Flag Post
HP Recommended

Stuck on initializing ink system for 8020

Hp 8020

Stuck on initializing for over hour. How long should it take

Tags (1)
1 REPLY 1
HP Support Agent
HP Support Agent
12,572 12,551 829 817
Message 2 of 2
61
Flag Post
HP Recommended

Stuck on initializing ink system for 8020

@Zee22

 

I have gone through your Post and would like to help

 

I suggest you perform a printer reset and also update the printer firmware

 

- Turn on the printer.
- Wait until the printer is idle and silent before you continue.
- Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
- Remove the ink cartridges from the printer.
- With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
- Wait at least 60 seconds.
- Plug the power cord back into the wall outlet.
NOTE: HP recommends connecting the printer power cord directly to a wall outlet.
- Reconnect the power cord to the rear of the printer.
- Turn on the printer, if it does not automatically turn on.
- The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
- Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
- Reinsert the ink cartridges, and then close the ink cartridge access door.
 

You can refer to this Link: https://support.hp.com/in-en/document/c02919168 for Firmware Update

 

Keep me posted how it goes

 

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.
 

KrazyToad
I Am An HP Employee

Reply
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation